Ag104 Scan Converter

The scan converter in Ag104 pitched a fit today. I am not sure what the cause of the problem was, but the result was that the scan converter would power up, but the system was not sending the signal to the control room. The big indicator was that the menu on the scan converter was not showing up. I tried to power it off and then back on, but that had no effect. It turns out that you need to go around to the back of the unit and unplug it fully for it to initiate a full reset. After that was done, the scan converter began working normally again.

(And a big "thank you!" to Daryl for figuring that out.)

 
Aberdeen Video/Audio Connection, connects at 384 and slides down to 192 with in 10 - 12 minutes. The last 4 times Ag 104 & AB have connected for the PLSC 547 class. The audio has become unstable, we'll wait small bit of time for it to clear up. It doesn't clear up, I disconnect and reconnect. A pattern, a clue has appeared, the audio has become unstable at 9:56 or 9:57 am PST, the last 3 times. Paula